FloPlast Anthracite Grey Push-Fit Air Admittance Valve - 110mm
Product code: 277074
£45
Out of Stock
Sorry, this product is out of stock
The FloPlast Push-Fit Air Admittance Valve allows a soil stack fitted with an external air admittance valve to terminate within three metres of a window opening. This allows the pipe to terminate at the same height as if it were installed internally, 200mm minimum above the highest wet entry point to the soil vent pipe. The use of an external air admittance valve eliminates the need for the soil stack to extend over the roof line saving on materials and time.
Read more
Read less
Saved to Project List
FloPlast Anthracite Grey Push-Fit Air Admittance Valve - 110mm
added to "My Project List".
You are not logged in to save your list permanently. Until you log in, your list will be saved temporarily and can only be accessed from the device you are using now.
Product details
- Standards Met: BS EN 12380
- Product Type: Fittings
- Diameter: 110 mm
- Material: PVCu
- Colour: Anthracite grey
- Years Guaranteed: 1
- Certifications Met: KM512474
- Type: Air admittance valves
- Brand Name: FloPlast
Features & benefits
- Allows the free entry of air into the sanitary pipework system without foul gasses escaping
- Manufactured in the UK from a combination of durable lightweight recyclable PVCu, ABS and rubber
- Zero waste to landfill from the manufacturing processes
- Fitted with an environmental mesh to restrict insect and environmental debris
- A1 designated which permits the valve to be fitted below the flood level of connected appliances, however it must be 200mm above the highest wet entry point to the soil vent pipe, Fully tested and operational at temperatures ranging from -20°C to +60°C
- Approved document H of the building regulations only permits air admittance valves that conform to BS EN 12380:2002
- Eliminates the need for the installer to work and handle pipe above the roof line (work at height (WAHR) and manual handling regulations)
- Compatible with all UK 110mm plastic soil pipe manufactured to BS EN 1329-1 or BS EN 1453
- Can be used as a rodding point
- Easy push-fit installation